Replacing The Battery; Cabling Digital Inputs/Outputs Via The Terminal Block - ADEUNIS ARF8283A Guide Utilisateur

LoRaWAN DELTA P - Guide utilisateur / User guide version V1.0.0

5.3. Replacing the battery

When the low battery indicator is activated (indicator in the frame or flashing red LED), change the internal battery of the case.
It is important to keep the same reference, ER18505
FR
EN

5.4. Cabling Digital inputs/outputs via the terminal block

In order to be able to couple a 0 -10 V sensor or dry contact sensors with the product, connect the sensor to the board terminal block.
Connecting the wires:
1. Open the case (paragraph 5.1)
2. Connect the wires as shown in the diagram below
3. Configure the registers associated with the connected sensors (paragraph 3)
4. Close the case
5. Restart the product with the magnet as for the initial start-up.
After this procedure, product will react as if it were the initial start-up
6
5
4
3
2
1
Examples :
LoRaWAN DELTA P may easily be coupled with a newer ventilation system with dry contact outputs. It may also be coupled with a current clamp
to monitor the voltage in the power cable of the ventilation system on which it is positioned and thus more readily detect a power failure.
Changing the battery:
1. Open the case (section 5.1)
2. Disconnect the wire from the existing battery, remove it from its holder, replace it
with the new one, remembering to connect the wire.
3. Close the case
4.
- If the product was in DEAD mode before the battery change, pass the magnet
blow. After this procedure, the product will react as if it were the initial start-up
(paragraph 5.2).
- If the product was not in fallback mode when the battery was changed, it will
automatically detect it after sending a few frames and remove the low battery
indicators (status and LED).
6
GND
5
0-10 V
GND 4
3
TOR2
2
GND
1
TOR1
Page 84 of 88