Summary Of The Conditions Of The Transmission Of The Uplink Frames - ADEUNIS sigfox RC4 Pulse Guide Utilisateur

sigfox RC4 Pulse - Guide utilisateur / User guide version V1.0.0
0x48
0
Code
0x48
0x48
FR
0
Code
0x48
0x48
EN
0
Code
0x48
0x48
0
Code
0x48
0x48
4.1.10

Summary of the conditions of the transmission of the uplink frames

The table below summarizes the conditions of the transmission of the different uplink frames:
Code
0x10 Frames of information on the
product configuration
0x20 Frames of information on the
network configuration
0x30 Keep Alive frame
0x31 Reply frame to a register value
request in a downlink frame
0x46 Data Frame
0x47 Alarm frame
0x48 (x4) Periodic frame with 1 hour-history
0x48 Periodic frame with 24 hours-
(x13) history
0xA3 8
1 2
Status
Cf Status Frame index
0xA3 9
1 2
Status
Cf Status Frame index
0xA3 10
1 2
Status
Cf Status Frame index
0xA3 11
1 2
Status
Cf Status Frame index
0xA3 12
Description
• Product start-up
• Exit from the configuration mode (AT Command)
• Reception of a downlink frame 0x01
• Periodically if the inputs are deactivated (period defined by register S301)
• Product start-up
• Exit from the configuration mode (AT Command)
• Reception of a downlink frame 0x02
24 hours elapse since the start-up of the product or since the last transmission of this frame
(5 minutes in TEST mode)
• Reception of a downlink frame 0x40
•
•
•
Exceeded flow threshold on one of the two channels (sending only if the exceeded flow
control is enabled by writing a non-zero value in the S326 or S327 registers).
1 hour elapses since the start-up of the product or since the last transmission of this frame
This frame is sent only if the history feature is activated in register S321.
24 hours elapse since the start-up of the product or since the last transmission of this frame
This frame is sent only if the history feature is activated in register S321.
0x074A
3 to 4
Delta A16
0x0100
3 to 4
Delta A18
0x00A5
3 to 4
Delta A20
0x00C3
3 to 4
PAYLOAD
Delta A22
0x0012
Sending conditions
Start-up of the product (RUN mode).
Exit from the configuration mode (AT commande)
Transmission period reached (period defined by register S301)
0x003B 0x0010
5 to 6 7 to 8
PAYLOAD
Delta B16 Delta A17
0x000F 0x0000
5 to 6 7 to 8
PAYLOAD
Delta B18 Delta A19
0x0000 0x0005
5 to 6 7 to 8
PAYLOAD
Delta B20 Delta A21
0x00F1 0x0005
5 to 6
Delta B22
0x0020
0x0021
9 to 10
Delta B17
0x00F1
9 to 10
Delta B19
0x00B5
9 to 10
Delta B21
0x00B5
Page 86 of 101