Error Messages/Troubleshooting - Beurer BC 85 Mode D'emploi

®
Transfer via Bluetooth
It is also possible to transfer the measured values saved on
the device to your smartphone using Bluetooth
You will need the "beurer HealthManager" app for this. This is
available in the Apple App Store and from Google Play.
Proceed as follows to transfer values:
®
If Bluetooth is activated in the settings menu, the data is
transferred automatically after the measurement. The
bol appears in the top left of the display (see chapter 4 "Pre-
paring the measurement").
Step 1:
Activate Bluetooth
4 "Preparing the measurement, Bluetooth
Step 2: "beurer HealthManager" app
In the "beurer HealthManager" app, add the
BC 85 under "Settings/My devices".
Step 3:
take a measurement.
®
.
BC 85
®
on your device (see chapter
BC 85
Step 4: BC 85:
data transfer immediately
following measurements.
• If Bluetooth
fer has been activated,
data is transferred after
having confirmed the user
sym-
memory and pressing the
START/STOP button
The "beurer HealthManager" app must be active to allow
data transfers.
If your smartphone has a protective cover, remove this to en-
®
").
sure that there is no interference during the transfer. Begin the
data transfer in the "beurer HealthManager" app.

8. Error messages/troubleshooting

In the event of errors, the error message E_ appears on the
display.
Error messages may appear if:
• It was not possible to record the pulse: E 1;
• You move or speak during the measurement:: E2 ;
• The cuff is fastened too tightly or loosely: E3;
• Errors occur during the measurement: E4;
• The pump pressure is higher than 300 mmHg: E5;
• The batteries are almost empty
• The data could not be sent via Bluetooth
In such cases, repeat the measurement. Ensure that you do not
move or speak. If necessary, reinsert or replace the batteries.
28
Step 4:
Data transfer at a later point:
• Go to memory mode
®
data trans- (chapter 7). Select the
desired user memory. The
Bluetooth
automatically.
.
E6.
BC 85:
®
transfer starts
®
: .