Beurer BC 85 Mode D'emploi page 24

Adopt the correct posture
• Before every measurement, relax for about five minutes.
Otherwise deviations can occur.
• You can take the measure-
ment while sitting or lying.
To take your blood pressure,
make sure you are sitting
comfortably with your arms
and back leaning on some-
thing. Do not cross your legs.
Place your feet flat on the ground. Make sure to rest your
arm and move it. Always make sure that the cuff is at heart
level. Otherwise significant deviations can occur. Relax
your arm and the palm of your hand. An O.K. symbol bar is
integrated into the device to additionally assist you. It sig-
nals the correct position of the blood pressure monitor. You
are in the right position if you can see O.K. on the display.
• To avoid falsifying the measurement, it is important to re-
main still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the posture in
which you want to perform the measurement.
• Press the START/STOP button
start the blood pressure monitor. All
displays will illuminate briefly.
The blood pressure monitor will begin the
measurement automatically after 3 sec-
onds.
The measurement is taken during the inflation phase.
to
24
You can cancel the measurement at any time by pressing
the START/STOP button
As soon as a pulse is found, the pulse symbol
• The systolic pressure, diastolic pressure
and pulse rate measurements are
displayed.
• E_ appears if the measurement could not be performed
properly. Observe the chapter on error messag-
es/troubleshooting in these instructions for use
and repeat the measurement.
• Now select the desired user memory by pressing
the M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most recently
used user memory. The relevant symbol M1 or M2 appears
in the display.
• Press the START/STOP button
pressure monitor. The measurement is then stored in the
selected user memory.
®
If Bluetooth data transfer is activated, data is transferred
after pressing the START/STOP button
®
• The Bluetooth symbol flashes on the display. The blood
pressure monitor now attempts to connect to the app for
approx. 30 seconds.
®
• The Bluetooth symbol stops flashing as soon as a connec-
tion is established. All measurement data is automatically
transferred to the app. Once the data has been successfully
transferred, the device switches off.
.
is displayed.
to switch off the blood
.