Transferring Measurements - Beurer BC 85 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
Individual measured values
• When the relevant memory button
(M1 or M2) is pressed again, the last
individual measurement is displayed
(in this example, measurement 03).
• When the relevant memory button
(M1 or M2) is pressed again, you can
view your individual measurements.
• To switch the device off again, press the START/STOP
button
.
You can exit the menu at any time by pressing the
START/STOP button
Deleting measured values
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start the retrieval of the average values.
• Press and hold the M1 or M2 memory buttons for 5 sec-
onds.
CL and 00 appear on the display.
All the values in the current user memory
are deleted.
The device will then switch off automati-
cally.
Deleting individual measurements
To clear individual measurements from the relevant user mem-
ory, you must first select a user memory.
• Start individual measurement access.
.
• Press and hold the memory button M1 or M2 for 5 seconds
(depending on the user memory you are in).
• The selected value is deleted. The device briefly displays CL 
00.
• If you would like to delete other values, repeat the process
described above.
You can switch off the device at any time by pressing the
START/STOP button

7. Transferring measurements

Transfers using the USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display. Begin the data
transfer in the "beurer HealthManager" PC
software. During the data transfer, an anima-
tion is shown on the display. A successful data
transfer is displayed as in figure 1. If the data
transfer is unsuccessful, an error message
appears as in figure 2. In this case, interrupt
the PC connection and start the data transfer
again.
After 30 seconds of not being in use or if
communication with the PC is interrupted,
the blood pressure monitor switches itself off
automatically.
27
.
figure 1
figure 2

Publicité

Table des Matières
loading

Table des Matières