Displaying And Deleting Measurements - Beurer BM 31 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

It is important to consult your doctor regularly for advice.
Your doctor will tell you your individual values for normal
blood pressure as well as the value above which your blood
pressure is classified as dangerous.
The classification on the display and the scale on the unit
show which category the recorded blood pressure values fall
into. If the systolic and diastolic values fall into two different
categories, the Risk Indicator on the device always shows
the higher category.

8. Displaying and Deleting Measurements

User Memory:
Every successful measurement is stored along with its
date and time. If there are more than 60 measurements in
a particular user memory bank, the oldest measurement is
deleted.
Press the +/- Buttons to select a user memory and confirm
by pressing the M Button. The most recent measurement
values will display.
Average Values:
• Press the M Button, after about three seconds of
displaying the most recent measurement, " "
flashes on the display and the average of all
saved measurements in the selected user
memory is displayed.
• Press the M Button again. " " flashes on the
display. The average value of the morning
measurements for the last seven days is
displayed (morning: 5:00 AM – 9:00 AM).
• Press the M Button a third time. " " flashes
on the display. The average value of the
evening measurements for the last seven days
is displayed (evening: 6:00 PM – 10:00 PM).
Individual Measured Values:
• Press the M Button again and the last
individual measurement is displayed. Continue
in this fashion to review older measurements.
• To shut the device off, press the Start/Stop
Button.
You can exit the menu at any time by pressing the START/
STOP Button
Clearing Memory:
• To clear one of the user memories, you must first select it.
• Start individual measurement access as described
above and select a user memory. After waiting
125
for three seconds for the average values to
83
display, press and hold the both the "
A
-
"
" Buttons at the same time for five seconds.
79
14
125
83
79
125
83
79
125
8:30
10/29
83
03
79
--
+
" and

Publicité

Table des Matières
loading

Table des Matières