Taking Measurement; Saving, Displaying And Deleting Measurements - Beurer BM 26 Mode D'emploi

return to normal. You may need to increase the wait
time depending on your individual physiological char-
acteristics. Because of normal physiologic changes and
the many external factors influencing blood pressure, it
is unusual to obtain identical blood pressure measure-
ments, even when taken a few minutes apart. Speak
with your physician to determine what is affecting your
blood pressure and which variation may be seen as
normal in your case.
• The accuracy of any blood pressure measurement with
this device can be affected by a multitude of causes.
Some can be avoided some have to be accepted at
the time of measurement. Speak with your physician
about possible causes affecting your blood pressure.
• If no button is pressed for approx. 1 minute the auto-
matic shut off function shuts off the unit in order to
preserve the batteries.
• Do not touch the unit, the tube and cuff and/or press
any buttons when measurement is in pro ress, except
for stopping the measurement. Doing so may cause
incorrect readings.

6.4 Taking Measurement

NOTE:
• If you are using the unit for the first time, please remove
the protective film from the display.
• Put on the cuff around your bare left upper arm as
described previously and assume the position in which
you want to carry out the measurement.
• Switch on the blood pressure monitor with the start/
stop button .
• Before the measurement, the last saved test result
is briefly displayed. If there is no measurement in the
memory, the instrument always displays the value "0".
• The cuff is pumped up. Cuff air pressure is released
slowly.
6.5 Saving, displaying and deleting measure-
ments
• The results of every successful measurement are stored
together with the date and time. If there are more than
30 measurements, the oldest measurements are lost.
• Press the - or + function button. Select the desired user
memory ( ... ) by pressing the -/+ function button. Con-
firm your selection with the START/STOP button
• If you press the memory button M, the average value A
of all the stored measured values in the user memory
will be displayed. If you press the memory button M
again, the average value of the morning measurements
for the last 7 days will be displayed. (morning: 5.00
– 9.00, display AM). If you press the memory button
M again, the average value of the evening measure-
ments for the last 7 days will be displayed. (evening:
18.00 – 20.00, display PM ). If you continue to press the
14
.