Taking Measurement - Beurer BM 55 Mode D'emploi

• The accuracy of any blood pressure measurement with
this device can be affected by a multitude of causes.
Some can be avoided some have to be accepted at the
time of measurement. Speak with your physician about
possible causes affecting your blood pressure.
• Do not inflate the cuff unless wrapped around arm.
• If no button is pressed for approx. 3 minutes the auto-
matic shutoff function shuts off the unit in order to pre-
serve the batteries.
• Do not touch the unit, the tube and cuff and/or press
any buttons when measurement is in progress, except
for stopping the measurement. Doing so may cause
incorrect readings.

6.3 Taking measurement

NOTE:
If you are using the unit for the first time, please remove
the protective film from the display.
• Put on the cuff around your bare left upper arm as de-
scribed previously and assume the position in which
you want to carry out the measurement.
• Switch on the blood pressure monitor with the START/
STOP button .
• Before the measurement, the last saved test result
is briefly displayed. If there is no measurement in the
memory, the instrument always displays the value '0'.
• The cuff is pumped up. Cuff air pressure is released slowly.
Performing a blood pressure measurement
As described above, attach the cuff and adopt the
posture in which you want to perform the measure-
ment.
• To start the blood pressure monitor,
press the START/STOP button
display elements are briefly displayed.
The blood pressure monitor will begin
the measurement automatically after 3
seconds.
The cuff automatically inflates.
Measuring can be cancelled at any time by press-
ing the START/STOP button
The cuff's air pressure is slowly released. If you already
recognize a tendency for high blood pressure, you
should reinflate the cuff and increase the cuff's pres-
sure again. As soon as a pulse is found, the pulse sym-
bol is displayed.
17
. All
.