Taking Measurement - Beurer Life BM 66/U Mode D'emploi

6.4 Taking measurement

Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• To start the blood pressure monitor,
press the Start/stop button
play elements are briefly displayed.
The blood pressure monitor will begin the
measurement automatically after 3 sec-
onds.
The cuff automatically inflates.
Measuring can be cancelled at any time by press-
ing the Start/stop button
The cuff's air pressure is slowly released. If you already
recognize having a tendency for high blood pressure,
you should reinflate the cuff and increase the cuff's
pressure again. As soon as a pulse is found, the pulse
symbol is displayed.
. All dis-
.
15
• Systolic pressure, diastolic pressure and
pulse measurements are displayed.
• A symbol at the bottom of the display
also lights up to indicate whether you
were sufficiently relaxed during the blood
pressure measurement (green symbol =
sufficiently at rest; red symbol = not at
rest).
Observe the chapter on interpreting re-
sults/measuring the resting indicator in
these instructions for use.
• appears if the measurement could
not be performed properly. Observe the
chapter on error messages/troubleshoot-
ing in these instructions for use and re-
peat the measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a us-
er memory, the measurement is stored in the most
recently used user memory. The relevant symbol
or appears on the display.