Preparing For Measurement - Beurer BM 31 Mode D'emploi

LCD Display Information:
1. Systolic Pressure
2. Risk Classification
Indicator
3. Diastolic Pressure
4. Irregular Heartbeat
Icon
5. Pulse Rate
6. Pulse Icon
7. Memory Space
Number/Average ( )/
Morning Reading (
/Evening Reading (
8. User Number
9. Deflation Icon
10. Low Battery Icon
11. Time and Date

5. Preparing for Measurement

Inserting/changing batteries:
1. Remove the Battery
Compartment Cover from
the rear of the device.
2. Insert four "AAA" alkaline
batteries (included)
according to the polarity
AM PM
11
10
9
8
7
6
5
4
)
)
4x1.5 V AAA (LR03)
markings inside the compartment.
1
NOTE: Do not use rechargeable batteries.
3. Reattach the Battery Compartment Cover.
All LCD Display elements will briefly appear and the year
value will flash. Set the date and time as described below.
2
Any saved measurements will be retained.
3
Operating with an AC Power Adapter:
You can also operate this device with an AC Power Adapter
(not included). You MUST remove the batteries before
powering this unit with an AC Adapter. Only use an AC
Power Adapter with specifications according to section
"Power supply unit".
1. Insert the round power plug from the AC Power Adapter
into the AC Adapter Jack on the right hand side of the
blood pressure monitor. Plug the AC Power Adapter into a
standard electrical outlet.
2. When finished using the device, unplug the AC Power
Adapter from the electrical outlet and disconnect it from
the blood pressure monitor. When you unplug the AC
Power Adapter, date and time settings will be lost but
saved measurements will remain.
Setting the hour format, date, and time:
If date and time are not set, stored measurements will not
have a valid timestamp associated with them.
10