Cleaning And Storing The Device And Cuff; Error Messages / Troubleshooting - Beurer BM 40 onpack Mode D'emploi

• Press the memory button M. The average value of all
saved measured values in this user memory is dis-
played first AL.
• If you press the memory button M again, the average
value of the morning measurements for the last 7 days
will be displayed (morning: 5.00 a.m. – 8.59 a.m., dis-
play A ).
• If you press the memory button M again, the average
value of the evening measurements for the last 7 days
will be displayed (evening: 6.00 p.m. – 7.59 p.m., dis-
play P ).
If there is no measurement in the memory, the de-
vice displays - - - .
• If you press the function buttons -/+
individual measured values are displayed in turn with
the date and time. By pressing the function button
+ + the most recent measurements are displayed; by
pressing the function button - - , the oldest are dis-
played.
-/+, the most recent
26
• To clear the memory of the relevant user memory, you
must first select a user memory. Start a request for ei-
ther average values or individual measured values and
press and hold the SET button for approx. 3 seconds.
All the values in the current user memory are deleted
after 3 brief beeps are output.
• You have the option to delete individual measured val-
ues by pressing the SET button when the measured
values are displayed after the measurement.
• To switch off, press the START/STOP button
• If you forget to switch off the device, it will switch off
automatically after 3 minutes.

8. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa-
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.

9. Error messages / troubleshooting

In case of faults, the message appears in the display.
Error messages can occur when
1: Systolic pressure is not detected,
•
2: Diastolic pressure is not detected,
•
.