Cleaning And Storing The Device And Cuff; Technical Specifications - Beurer BC 40 Mode D'emploi

In such cases, repeat the measurement. Ensure that you do
not move or speak during the measurement. If necessary,
reinsert or replace the batteries.

9. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries.

10. Technical specifications

Model no. BC 40
Measurement Oscillometric, non-invasive blood pressure
method measurement on the wrist
Measurement Cuff pressure 0 – 290 mmHg,
range Systolic 50 – 250 mmHg,
Diastolic 40 –180 mmHg,
Pulse 40 – 180 beats/minute
Display Systolic ± 3 mmHg, diastolic ± 3 mmHg, pulse
accuracy ± 5 % of the value shown
Measurement Max. permissible standard deviation
inaccuracy according to clinical testing: systolic 8 mmHg/
diastolic 8 mmHg
Memory 60 memory spaces
Dimensions L 76 mm x W 70 mm x H 23 mm
Weight Approximately 105 g
(without batteries, with cuff)
Cuff size 12.5 to 21.5 cm
Permissible + 10 °C to + 40 °C, ≤ 85 % relative humidity
operating (non-condensing)
conditions
Permissible - 5°C to + 50 °C, ≤ 85 % relative humidity,
storage 800-1060 hPa ambient pressure
conditions
Power supply
2 x 1.5V
Battery life For approx. 300 measurements, depending on
levels of blood pressure and pump pressure
Classification Internal supply, continuous operation,
application part type BF, IP22, no AP or APG
The serial number is located on the device or in the battery
compartment.
Technical information is subject to change without notifica-
tion to allow for updates.
28
AAA batteries