Saving, Retrieving And Deleting Results; Cleaning And Storing The Device And Cuff; Error Messages / Troubleshooting - Beurer BM 26 Mode D'emploi

Blood pressure Systole
value category (in mmHg)
Setting 3: ≥ 180
severe
hypertension
Setting 2: 160 – 179 100 – 109
moderate
hypertension
Setting 1: 140 – 159 90 – 99
mild
hypertension
High normal 130 – 139 85 – 89
Normal 120 – 129 80 – 84
Optimal < 120
Source: WHO, 1999 (World Health Organization)

7. Saving, retrieving and deleting results

• The results of each successful measurement are stored to­
gether with date and time. With more than 30 items of meas­
ured data, the earliest items of data measured are lost.
• Use the SET button and then the -/+ buttons to select the
desired user memory and confirm using the button
ing the M+ button displays the average value AVG of the 3
most recent measurements stored in the user memory. By
pressing the + button, the most recent measurements are
displayed; by pressing the - button, the oldest are displayed.
• The average value AVG can only be displayed if there are 3
saved values in the respective user memory.
Diastole Action
(in mmHg)
≥ 110 seek medical at­
tention
seek medical at­
tention
regular monitoring
by doctor
regular monitoring
by doctor
self­monitoring
< 80 self­monitoring
. Press­
• To clear the memory, you must first select a user memory.
Hold the SET button pressed for approx. 3 seconds. All the
values in the current user memory are deleted after 3 brief
beeps are output.
• If you wish to change the user memory, see "Select memory".

8. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa­
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.

9. Error messages / troubleshooting

In case of faults, the
Err
Error messages can occur when
1. inflation pressure is higher than 300 mmHg,
2. blood pressure is unusually high or low,
3. you move or talk during the measurement.
In the above cases, you must repeat the measurement. Make sure
that the cuff tube is properly inserted and that you do not move or
talk. Re­insert the batteries if necessary, or else replace them.
22
message appears in the display.