Important Information - Beurer BM 26 Mode D'emploi

2. Important information

Signs and symbols
The following symbols are used in these instructions for use, on
the packaging and on the type plate for the device and acces­
sories:
Attention
Note
Note on important information
Observe the instructions for use
Application part, type BF
Direct current
Disposal in accordance with the Waste Elec­
trical and Electronic Equipment EC Directive
– WEEE
Dispose of packaging in an environmentally
21
friendly manner
PAP
Manufacturer
Permissible storage and transport temperature
Storage / Transport
and humidity
Permissible operating temperature and humid­
Operating
ity
Protect from moisture
Serial number
SN
The CE labelling certifies that the product
complies with the essential requirements of
Directive 93/42/EEC on medical devices
Certification symbol for products that are
exported to the Russian Federation and mem­
bers of the CIS
Advice on use
• In order to ensure comparable values, always measure your
blood pressure at the same time of day.
• Before every measurement, relax for about five minutes.
• If you want to perform several measurements on the same
person, wait five minutes between each measurement.
• Do not take a measurement within 30 minutes after eating,
drinking, smoking or exercising.
• Repeat the measurement if you are unsure of the measured
value.
• The measurements taken by you are for your information
only – they are not a substitute for a medical examination!
Discuss the measurements with your doctor, and never base
15