Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service page 110

English
No. Designation
5.7.2.0 Delivery head
correction for
in-line pumps
5.7.2.0 Delivery head
correction for
monobloc pumps
5.7.5.0 Switching
frequency
5.7.6.0 SBM function
5.7.7.0 Factory setting
5.8.0.0 Other settings 2
5.8.1.0 Pump kick
110
Type Symbol Values/explanations
±
When delivery head correction is
enabled, the differential
pressure deviation measured by
the differential pressure sensor
that is factory-fitted on the
pump flange is taken into
account and corrected.
Delivery head correction off
Delivery head correction on
(factory setting)
±
When delivery head correction is
enabled, the differential
pressure deviation measured by
the differential pressure sensor
that is factory-fitted at the
pump flange as well as the
different flange diameter is
taken into account and
corrected
Delivery head correction off
Delivery head correction on
(factory setting)
HIGH
High switching frequency
(factory setting)
MID
Medium switching frequency
LOW
Low switching frequency
±
Setting for behaviour of signals
SBM run signal
SBM readiness signal
SBM mains on signal
±
OFF (default setting)
Settings are not changed by
confirming
ON
Confirming will reset the
settings to factory settings
Caution!
All manual settings will be lost
Display conditions
Only displayed in Δp-c mode.
Is not displayed for all pump
variants
Only displayed in Δp-c and
Δp-v mode.
Is not displayed for all pump
variants
Carry out the switchover/
change only when the pump
is at a standstill (not when
the motor is running)
Is not displayed when access
disable active. Is not
displayed when BMS is active
Is not displayed when access
disable active. Is not
displayed when BMS is active
For parameters that are
changed by a factory setting,
see chapter 13 "Factory
settings" on page 131
Not displayed for all pump
types
WILO SE 04/2020