Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service page 100

English
"One level down" menu element
"Information" menu element
"One level up" menu element
"Selection/setting" menu element
8.5.3 Display error page
Fig. 31: Error page (status in the event of an
error)
8.5.4 Menu groups
Basic menu
Info menu
Service menu
100
Every menu level can contain four different element types:
The "One level down" menu element is indicated on the display by the
symbol shown here (arrow on the units display). If a "One level down"
menu element is selected, pressing the operating button causes a
change to the next menu level down. On the display, the new menu
level is indicated by a menu number that has increased by one digit as
a result of the change; for example, menu <4.1.0.0> changes to menu
<4.1.1.0>.
The "Information" menu element is indicated on the display by the
symbol shown here (standard symbol for "access disable"). If an
"Information" menu element is selected, pressing the operating but-
ton has no effect. When an "Information" menu element is selected,
current settings or measurements that cannot be changed by the user
are displayed.
The "One level up" menu element is indicated on the display by the
symbol shown here (arrow on the symbol display). If a "One level up"
menu element is selected, briefly pressing the operating button causes
a change to the next higher menu level. On the display, the new menu
level is indicated by the menu number. For example, when returning
from menu level <4.1.5.0>, the menu number jumps to <4.1.0.0>.
NOTICE:
If the operating button is pressed for 2 seconds while a "One level up"
menu element is selected, the display jumps back to the status page.
±
The "Selection/setting" menu element does not have a special label
on the display, but is identified graphically in these instructions by the
adjacent symbol.
If a "Selection/setting" menu element is selected, pressing the oper-
ating button will change to edit mode. In edit mode, flashing values
can be changed by turning the operating button.
In some menus, acceptance of the input by pressing the operating
button will be confirmed by the brief display of the "OK" symbol.
E000
If an error occurs, the error page will be shown on the display rather
than the status page. The value display shows the letter "E" and the
E.025
three-digit error code separated by a decimal point (Fig. 31).
Basic settings are shown in the main menus <1.0.0.0>, <2.0.0.0> and
<3.0.0.0>, which provide access to set values that may have to be
changed during regular pump operation.
The main menu <4.0.0.0> and its sub-menu elements show measur-
ing data, device data, operating data and current states.
The main menu <5.0.0.0> and its sub-menu elements provide access
to basic system settings for commissioning. The sub-elements are in
a write-protected mode as long as service mode is not activated.
CAUTION! Risk of property damage!
Incorrect setting changes can lead to pump operation errors, which
can lead to pump or system damage.
• Settings in service mode should only be made during commission-
ing and only by qualified personnel.
WILO SE 04/2020