Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service page 108

English
No. Designation
5.1.2.0 Setting, MA/SL
5.1.3.0 Pump cycling
5.1.3.1 Manual pump
cycling
5.1.3.2 Internal/external
5.1.3.3 Internal: Time
interval
5.1.4.0 Pump enabled/
disabled
5.1.5.0 SSM
5.1.6.0 SBM
5.1.7.0 Extern off
5.2.0.0 BMS
5.2.1.0 LON/CAN/IF
module
Wink/service
5.2.2.0 Local/remote
operation
5.2.3.0 Bus address
108
Type Symbol Values/explanations
Parallel operation
±
Manual switching from master
to slave mode
±
Carries out pump cycling
independent of the countdown
±
Internal pump cycling
External pump cycling
±
Can be set between 8 h and 36 h
in 4 h steps
±
Pump enabled
Pump disabled
±
Individual fault signal
Collective fault signal
±
Individual readiness signal
Individual run signal
Collective readiness signal
Collective run signal
±
Individual Extern off
Collective Extern off
Settings for Building
Management System (BMS) –
building automation
±
The wink function permits the
identification of a device in the
BMS network. A "wink" is
executed by confirmation.
±
BMS local operation
BMS remote operation
±
Setting of bus address
Display conditions
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master, see "AUX"
terminal
Displayed when internal
pump cycling is activated
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Is only displayed for
twin-head pump master and
SBM function at readiness/
operation
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Only displayed for twin-head
pump master
Incl. all sub-menus, only
displayed when BMS is active
Only displayed when LON,
CAN or IF module is active
Temporary state, automatic
reset to remote operation
after 5 min
WILO SE 04/2020