Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service page 105

No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
2.3.2.0 Δp-v gradient
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values
sensor (In1)
4.1.3.0 Power
4.2.0.0 Operating data
4.2.1.0 Operating hours
4.2.2.0 Consumption
4.2.3.0 Countdown, pump
cycling
4.2.4.0 Remaining time
until pump kick
Installation and operating instructions Wilo-Stratos GIGA, GIGA-D, GIGA B
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 101)
±
Setting/display of the control
mode (for further information,
see chapters 6.2 "Control
modes" on page 81 and 9.4
"Setting the control mode" on
page 114)
Constant speed control
Constant Δp-c control
Variable Δp-v control
PID-Control
Setting the gradient of Δp-v
(value in %)
±
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode.
Δp-c, Δp-v: Value H in m
PID-Control: Value in %
Current power input P
Display of operating data
Sum of the pump's active hours
of operation
(counter can be reset by infrared
interface)
Energy consumption in
kWh/MWh
Time to pump cycling in h
(at a resolution of 0.1 h)
Time until the next pump kick
(after the pump has had a 24 h
standstill (e.g. via Extern off),
it will be automatically operated
for 5 seconds)
(11-22kW)
Display conditions
Not displayed for all pump
types
Not displayed for constant
speed
in W
1
The operating data refers
to the electronic module
currently being operated
Shown only for twin-head
pump master and internal
pump cycling. Can be set in
the service menu <5.1.3.0>
Only displayed if pump kick is
activated
English
105