Troubleshooting - Graef SKS 700 Instructions D'utilisation

Troubleshooting

Problem
Unit cannot be
switched on
Carriage is sluggish
Grinding noises on the
blade
Blade is sluggish or
stops under load
Operating noise in-
creases with rising use
Blade is loose, swings
and strikes against the
housing
The cut slicing material
is pulled behind the
blade
The Blade does not cut
well any more
46
Cause
Switch-on guard acti-
vated
Carriage guide is
soiled
Food residues on the
blade
Blade gear not suf-
ficiently greased, or
soiled
Gear is not sufficiently
greased
Carriage ring not
inserted
Blade cover plate not
mounted
The slicing material is
not correctly scraped
off
The blade is dull and
must be sharpened
Solution
Unlock switch-on
guard
Clean and grease the
sliding guide
Remove the blade.
Clean the scraper, car-
riage ring and blade,
grease, if necessary.
Remove the blade,
clean it and grease the
inside of the blade, in-
cluding the blade gear
using petroleum jelly.
Remove the blade.
Clean and grease the
blade gear and motor
screw.
Make sure that the car-
riage ring is correctly
inserted
Please ensure that
the blade cover plate
is always correctly
mounted.
Make sure that the
scraper is correctly
inserted and undam-
aged.
Re-sharpen the blade
using the blade sharp-
ener contained in the
scope of delivery.