Electrical Wiring Diagram - Tekno Point WINE-14 Manuel D'utilisation Et Installation

3.3. Electical connections

3.3.1. Electrical wiring diagram

3.3.2. Cabling
Regerring to Pic. 3.3.2:
• Remove the cover of the electrical
connection box, located on the rear of
the machine, unscrewing the for screws
V.
• Pass the electrical power supply cable
through the cable holder P.
• Take off the terminal board M from the
box.
• Connect phase, neutral and earth cable
on the first three terminals of the
terminal board.
• Put the terminal board back into the
electrical box carefully inserting the
metal bracket into the slides G.
• Close the electrical connection box.
mini NEB
Pic. 3.3 Pic. 3.3. . . . 1 1 1 1 – – – – Wiring diagran Wiring diagran
Pic. Pic. 3.3 3.3 Wiring diagran Wiring diagran
Pic Pic. . . . 3.3 Pic Pic
4 / 10
1 1 1 1 Humidifier motor
2 2 2 2 Floating switch
3 3 3 3 Solenoid Valve
4 4 4 4 External Humidistat Bridge
Condenser
5 5 5 5
~ 275 V, 0.22 F, X2 class
External Humidistat 230V,
A A A A
50/60 Hz, 0,2A (Optional)
Line Protection (Not
B B B B
Supplied)
Tab. 3.3 Tab.
Tab. Tab.
The control and safety
devices, that are to be fitted
by the installer, must include
an adequate disconnecting
switch on both power supply
lines.
3.3 3.3 3.3. . . . 2 2 2 2
M836-GB-1
3.3. . . . 1 1 1 1
3.3 3.3