Tekno Point WINE-14 Manuel D'utilisation Et Installation page 49

manuale di istruzioni uso e manutenzione WINE-14
STEP 4:
- fix the support bracket to the wall;
- check that the bracket has been mounted
on level;
- hang up the air conditioner;
c. Installation of air expulsion suction kit
- insert the PVC pipes diam. 125, female side,
from the outside of the wall to the
male attachment on the machine;
- cut the 2 PVC suction and expulsion pipes
flush with the outer wall;
Seal well, outside the wall, the remaining space
•
between the through hole of the wall and the plastic
pipe for air intake and expulsion with the black
elastomer pipes supplied as shown in the photo.
• Seal the remaining space between the through-hole of the
wall and the plastic air intake and exhaust pipe with black
elastomer pipes supplied as in the photo.
place the two grids on the air intake and exhaust pipes:
•
NB: Pay attention to air aspirations / expulsions leading both to the same lupo or underground
wells since the suction pipe can recirculate the hot air expelled from the air conditioner and
compromise the operation of the air conditioner.
www.teknopoint.com
treated hot air expulsion:
•
tioned oriented at about 45 °;
•
external air intake:
•
end of the lower tube with an inclination of about 45 ° opposite to
the upper one;
NB: the rotation of the grids serves to avoid that the IN-OUT
air flows cross each other.
Pag. 8
grid without retina to be posi-
grid with retina to be mounted at the