Humidifier Installation - Tekno Point WINE-14 Manuel D'utilisation Et Installation

manuale di istruzioni uso e manutenzione WINE-14

humidifier installation

There are 2 STD and optimal humidifier mounting
positions:
• next to the monobloc at the height of the air out-
let at a distance of at least about 40 cm (see dia-
gram opposite) the water must NOT be sprayed
against the air conditioner and washed away; to
the right or left it makes no difference;
• under the block, centered, at a distance of at
least 20/25 cm (see next pto h. Assembly view
(preferable solution);
It is important that the sprayed water is directed towards the air
outlet of the air conditioner and never against the air conditioner
itself.
(1) The humidifier must be fixed to the wall with three screws and
special support plugs;
(2) Using the supplied flexible hose, connect the humidifier to the
aqueduct;
(3) using the hose connector at the bottom, the discharge of the
water at the end of the cycle is connected to the condensation
drain pipe of the air conditioner, by means of a Y-joint.Per l'instal-
lazione avvalersi del libretto del produttore allegato alla merce.
The installation of the humidifier involves the connection to the water supply and drainage
pipes. The tubes, supplied as standard with the humidifier, must be collegati
come di seguito descritto
The supply hose (A) has two female ¾
"threads at both ends: connect the L-
shaped end (elle) to the solenoid valve,
the other end (the straight end) directly
to a tap (B)
It is advisable to install a mechanical
filter C downstream of the tap (B), as
shown in the figure above. For water
drainage use the plastic pipe (D),
supplied as standard, or a similar one that has an internal diameter of 10mm.
The pipe must be installed as shown above with a minimum slope of 10 °, in order to guarantee
the correct water discharge. Any siphon E must be on the main drain and not on the exhaust
pipe connected to the machine.
www.teknopoint.com
Pag. 10