General Safety Rules; Main Components - Tekno Point WINE-14 Manuel D'utilisation Et Installation

2. Introduction
The MININEB is a room humidifier, working by the principle of atomizing water by mean of centrifugal
force. The machine must be feeded by tap water or fully demineralized water. For a correct functioning of
the machine, it's very important to follow the below installation rules.

2.1. General safety rules

The machine must be connected to an electric installation that complies the local regulations, by an
electric control box including all safety and control devices.
Before starting any kind of intervention on the machine, remember to disconnect the electrical power
supply, using the main switch located in the electrical control box.
After any kind of intervention on the machine, be sure, after completing the work, that no tools of any
kind are left inside before restart. Installation and maintenance of the machine must be made by expert,
qualified personnel able to do the work following the instructions written on this manual.
This machine has been designed for air humidification, and any other use different from this is strongly
not recommended. Any utilization different from the one described in the present manual is to be
considered improper, and potentially dangerous and harmful.
Keep those instructions in a safe place for future reference.

2.2. Main components

mini NEB
2 / 10
1 Air Diffuser
2 Electric Motor
3 Atomizing Disk
4 Suction Cone
5 Drain Siphon
6 Body
7 Air Filter
Tab. 2.2 Tab. Tab. Tab. 2.2. . . . 1 1 1 1 2.2 2.2
M836-GB-1