Mounting Input/Output Module(S) - Aventics DDL Mode D'emploi

102 AVENTICS | DDL | R499050020–BDL–001–AD
Disassembly and Exchange
7. Make all the presettings on the new bus coupler (4)
(see "Making presettings" on page 85).
8. Reestablish the connections.
9. Check the configuration and adjust if necessary.
8.2

Mounting input/output module(s)

Input and output modules can be added to the valve system.
Applied voltage and high pressure!
Danger of injury from electric shocks and sudden pressure
drops.
O
Make sure the system is not under pressure or voltage
before you install the modules.
Open inputs/outputs
Danger of electric shocks caused by contact, short circuits, or
damage to the system.
O
Always close unused inputs or outputs with M12 and
M8 protective caps (see "Spare parts and accessories") to
comply with the IP 65 protection class.
CAUTION
CAUTION