Installing Robin Mover - Invacare Robin Manuel De Maintenance

Invacare® Robin™
4. Locate the hoist trolley at the Ø 32 mm round recess in the rail.
5. Lift the hoist and push the suspension pin through the trolley
opening.
6. Turn the hoist by 90 degrees to fix it in the trolley.
7. Connect the hand control.
8. Adjust the length of the emergency stop/lowering cord to within
the user's reach.
8
If there is excessive resistance, or if the trolley unintentionally
rolls by itself due to imbalance in the rail suspensions, adjust
the friction brake using a 4 mm Allen key.

3.1.2 Installing Robin Mover

The trolley is built-in on the hoist, and can therefore not be pre
installed in the rail.
Tools: 4 mm Allen key; 17 mm socket wrench
1. Remove the end stop.
1586747-A