Dismounting Robin Mover - Invacare Robin Manuel De Maintenance

Invacare® Robin™
1. Lift the hoist slightly and push the suspension pin out of its
holder in the trolley.
2. Turn the hoist by 90 degrees and pull it out of the trolley.
Remove the trolley from the rail
1. Remove the end stop.
2. Slide the trolley out of the rail.

3.2.2 Dismounting Robin Mover™

1. Pull the emergency strap to prevent accidental activation of the
ceiling hoist after it has been dismounted from the rail.
2. Remove the end stop.
10
3. Slide the wheels of the hoist out of the rail.
4. Install the end stop.
Tighten the bolt to 30 Nm.
5. If removing the hoist from the rail motor, perform the following
steps:
When replacing the battery or performing service, it is
also necessary to remove the hoist from the rail motor.
1586747-A