Technical Data; The Rail System; Dimensions And Weight - Invacare Robin Manuel De Maintenance

6 Technical data

6.1 The rail system

All rail profiles are manufactured in extruded aluminium.
The rails are available with white powder coating.
The rails are available in three different heights; S= 68 mm, M=114
mm and L=183 mm, providing a fee span of 2 m, 4 m and 8 m,
respectively.
The profile width of all three profiles is 58 mm. The top of the
profiles are shaped to permit the coupling of the rails to the
installation brackets.
On delivery, the rail for the hoist will feature a milled groove on
its bottom. This groove is used for hoist installation and is called
keyhole.
Possible installations
Single rail can be installed on the ceiling or onto the wall and
floor. The rail position in the room can be either parallel to a wall
or angular in relation to a wall.
The traverse system can be installed on the ceiling or onto the
wall and floor. The free span between the two parallel rails can be
up to 8000 mm.
Curves are available in the S-profile and can be installed on the
ceiling. They are available in angles of 30°, 45°, 60° and 90°.
Special solutions
Installation with pendling brackets is used in the following cases:
When the height of the ceiling varies in the lengthwise direction of
the rail, or when the rail is to be countersunk.
1586747-A
Angular installation is used when the rail has to be installed in
other angles than 90°.

6.2 Dimensions and weight

Dimensions
Hoist length (A)
Hoist width (B)
Hoist height (C)
Maximum lifting range (D)
Weights
Maximum lifting capacity (Safe
Working Load)
Total weight without sling
Technical data
Robin
Robin™
Mover™
470 mm 470 mm
250 mm 250 mm
203 mm 266 mm
2.5 m 2.5 m
Robin
Robin™ Mover™
200 kg 200 kg
7.3 kg 10 kg
29