Replacing The Pcb (Printed Circuit Board) - Invacare Robin Manuel De Maintenance

Invacare® Robin™
4. Plug in the wires A.
5. Re-assemble the hoist and reset the emergency stop.

3.7 Replacing the PCB (Printed Circuit Board)

CAUTION!
Static electricity can damage the PCBs inside the hoist.
Before working in the inside of the hoist:
– Pull the red emergency strap to turn off the hoist.
– Remove the hoist from the track system. (Refer to 3.2
Dismounting the ceiling hoist, page 9 )
– Remove the cover from the hoist. (Refer to 3.4
Removing the hoist cover, page 12)
– An anti-static mat must be used when working inside
the ceiling hoist.
14
1. Remove the battery. Refer to steps 1 and 2 in chapter 3.6
Replacing the battery, page 13.
2. Remove all plugs B, C, D, E and F from the PCB A.
Release the PCB A from the retaining holders by gently pressing
3.
down the locking clips and levering the PCB slightly away from
the chassis plate.
4. Lift the PCB up to remove.
5. Place the new PCB into the chassis and press it slightly against
the chassis plate until the retaining holders snap into place.
6. Connect the plugs B, C, D, E and F to the new PCB.
7. Re-insert battery, re-assemble the hoist and reset the emergency
stop.
1586747-A