Electromagnetic Compliance (Emc) Information; Guidance And Manufacturer's Declaration - Invacare Robin Manuel De Maintenance

6.5 Electromagnetic compliance (EMC)
information
Medical Electrical Equipment needs to be installed and used according
to the EMC information in this manual.
This equipment has been tested and found to comply with EMC limits
specified by IEC/EN 60601-1-2 for Class B equipment.
Portable and mobile RF communications equipment can affect the
operation of this equipment.
Other devices may experience interference from even the low levels
of electromagnetic emissions permitted by the above standard. To
determine if the emission from the lift is causing the interference, run
and stop running the lift. If the interference with the other device
operation stops, then the lift is causing the interference. In such rare
cases, interference may be reduced or corrected by the following:
•
Reposition, relocate, or increase the separation between the
devices.

6.5.1 Guidance and manufacturer's declaration

Basic
Test Standard
Mains Port
EN
Conducted
55011:2007
Emissions
Radiated EN
Emissions 55011:2007
EN 61000-
3-2:2006 +
Mains Harmonics
A1:2009 +
A2:2009
1586747-A
Compliance Level /
Frequency Range
Group 1 Class B
Group 1 Class B
Class A
Basic
Test Standard
Voltage EN 61000-3-
Fluctuations 3:2008
Electrostatic EN 61000-4-
Discharge 2:1995
Radiated Field EN 61000-4-
Immunity 3:2006
EN 61000-4-
EFT/Bursts
4:2004
EN 61000-4-
Surge Immunity
5:2006
Conducted RF EN 61000-4-
Immunity 6:2007
Magnetic Field EN 61000-4-
Immunity 8:1993
Dips & EN 61000-4-
Interruptions 11:2004
Technical data
Compliance Level /
Frequency Range
dc%/dmax/d(t)/Pst
±2/4/6kV Contact,
±2/4/8kV Air
3V/m, 80% 1kHz AM,
80MHz - 2.5 GHz
±2kV L/N/E/LNE
±0.5/1kV L-N, ±0.5/1/2kV
L-E/N-E
3V, 80% 1kHz AM, 0.15MHz
- 80MHz
3A/m, 50Hz & 60Hz
-95%/-60%/-30%
31