Publicité
ULTRAFLEX
3.1.3 Periodic interventions
The periodical maintenance must be carried out by specialized operators.
After the first 20 hours of operation and afterwards every 100 hours or 6 months
… All the points referred to in paragraph 3.1.2.
… Check the seal of all the connections and check the tightening torque of all fasteners in the whole system.
… Check the absence of mechanical backlash or the inaccuracy of the steering wheel during the steering.
… Check all electrical connections for any rubs and cuts.
After the first 200 hours of operation or every 12 months
… Check the grip of all fittings and fasteners throughout the system.
… Perform all scheduled checks after 100 hours or 6 months.
… Check possible damages or deterioration on the hydraulic hoses.
… Check possible damages or deterioration on the electrical cables of the system.
… Check of the correct insertion and/or tightening of all connectors located on the system.
… When checking the electric cables, make sure that the interconnections have not been damaged while han-
dling them. Check that the ground connections have no surface oxidation. In that case, we recommend using
sprays or common products to protect and preserve the electric contacts
… Check of the components fastening the system.
… Check the absence of corrosion or damage on the system components.
… Check Silent Block integrity.
… Check the contamination status of the hydraulic oil in the system. Replace it if necessary.
page 36
of 119 -
INTEGRA SYSTEM
User manual
Publicité
