Tiller Handle Height/Angle Adjustment - HONDA marine BF40D Instructions D'utilisation

TILLER HANDLE HEIGHT/ANGLE
ADJUSTMENT
The tiller handle height/angle can be adjusted in
three positions by changing the installation direction
of the height adjustment block.
Select a suitable height/angle for the operator and
secure the block.
1) Raise the tiller handle and remove the 10 x 32
mm flange bolt and the height adjustment block.
2) Pull down the tiller handle. Determine the height
adjustment block installation direction and secure
the block with the 10 x 32 mm flange bolt.
Install the height adjustment
block so that the selected
angle is in this position.
HEIGHT ADJUSTMENT
BLOCK
HANDLE ANGLE: 7°
HANDLE ANGLE: 13°
10 x 32 mm
FLANGE
BOLT
HANDLE ANGLE: 21°
23
HANDLE ANGLE: 7°
HANDLE ANGLE: 13°
HANDLE ANGLE: 21°
Z point
HANDLE
HEIGHT