Electromagnetic Compliance (Emc); Guidance And Manufacturer´s Declaration - Electromagnetic Immunity - Invacare Birdie Manuel D'utilisation

Invacare®Birdie™

10.6 Electromagnetic compliance (EMC)

Guidance and manufacturer´s declaration – electromagnetic emission
The patient lift is intended for use in the electromagnetic environment specified below. The customer or the user of the patient lift should assure
that it is used in such an environment.
Emissions test Compliance
RF emissions
Group I
CISPR 11(partly)
RF emissions
Class B
CISPR 11(partly)
Harmonic emissions
Class A
IEC 61000-3-2
Voltage fluctuations /
flicker emissions Complies
IEC 61000-3-3
Guidance and manufacturer´s declaration – electromagnetic immunity
The patient lift is intended for use in the electromagnetic environment specified below. The customer or the user of the patient lift should assure
that it is used in such an environment.
Immunity test IEC 60601 test level
Electrostatic
± 6 kV contact
discharge (ESD)
± 8 kV air
IEC 61000-4-2
Electrostatic ± 2 kV for power supply
transient / burst lines
IEC 61000-4-4 ± 1 kV for input/output lines
46
Electromagnetic environment - guidance
The patient lift uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
The patient lift is suitable for use in all establishments including domestic establishments
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Compliance level
± 6 kV contact
± 8 kV air
± 2 kV for power supply
lines
± 1 kV for input/output lines
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile. If floors
are covered with synthetic material, the relative humidity
should be at least 30 %.
Mains power quality should be that of a typical commercial
or hospital environment.
1575480-B