Assembling The Electric Actuator To The Boom; Mounting The Hanger Bar - Invacare Birdie Manuel D'utilisation

Invacare®Birdie™
1. Lock both rear casters B. Remove the locking pin A.
2. Raise the mast assembly C to an upright position by stepping
with one foot on the leg D and pulling the handle bar E upwards
until it locks in place.
Reinstall the locking pin A through the mast G and base F.
3.
Ensure that the locking pin is correctly inserted.
4.3 Assembling the Electric Actuator to the
Boom
1. Loosen the hanger bar by pulling it downwards out of the welded
fork on the mast.
Remove the quick release pin A from the boom mounting
2.
bracket B.
14
3. Align the holes of the boom mounting bracket with those of
the actuator C.
4. Reinstall the quick release pin A and secure with the clip D.
Be sure that the pin is completely through the holes of
the boom mounting bracket and the actuator assembly.
The boom assembly will pivot easily if the mounting
hardware is aligned properly when the boom is secured
to the mast.

4.4 Mounting the hanger bar

WARNING!
Risk of injury
– Use only hanger bars made for this lift ("Coat Hanger
Bar System").
– Make sure the hanger bar is suitable for the patient
and the actual lift or transfer required.
– Check that the hanger bar is firmly attached to the
carabiner. The safety catch of the carabiner must be
closed after the hanger bar is mounted and before
lifting the patient. There is risk of detachment if the
safety catch is not correctly closed.
1575480-B