Playing Back Tapes (On Either Deck A Or B) - Sony R5520 Mode D'emploi

SYSTEM
POWER
== C2 RELAY
DIRECTION
De
Playing Back Tapes
(on either Deck A
or B)
This section describes about a basic
playback operation on either deck A or B.
1 Press TAPE.
"TAPE" appears on the display.
2 Press & to open the cassette
compartment, insert the tape and
close the cassette compartment.
3 Set DOLBY NR to the same
position that was used when the
cassette was recorded.
4 Set DIRECTION.
== C> RELAY
To playback
one side
only
DIRECTION
Qe
To'playback == C> RELAY
both sides
continuously* DIRECTION
* After playing back five times,
playback automatically stops.
5 press <1 or (> to start playback.
To playback from the front side,
press >.
To playback from the reverse side,
press <J.
The tape direction indicator lights up to
show the side you are listening.
To stop playback, rewinding or fast
forwarding, press @.
To pause, press Ih.
To resume playback, press Ul, <J or >.
To fastwind a tape rightward, press PP.
To fastwind a tape leftward, press <4.
Notes
* During playback or recording on a deck,
do not operate the other deck. (When
both decks A and B are in playback
mode, only playback from deck A will be
audible.)
Before turning the power off, be sure to
stop playback or recording by pressing
a.
What is the Dolby* NR system?
Dolby NR (noise reduction) system reduces
tape hiss noise in low-level, high-frequency
signals. The system boosts these signals in
recording and lowers them in playback.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol 00 are
trademarks of Dolby Laboratories Licensing
Corporation.