Textron Jacobsen CUSHMAN Turf Truckster Manuel De Maintenance page 33

5.30 EFI DIAGNOSTIC CHECK ___________________________________________________
Suzuki Gas Engine units only
The electrical system is equipped with an OBD-II
diagnostic connector.
Manual transmission: Engage parking brake, shift
transmission to Neutral, and turn the ignition switch to the
OFF position.
Automatic Transmission: Engage parking brake, place
gear selector in Park, and turn the ignition switch to the
OFF position.
5.31 CARE AND CLEANING _____________________________________________________
Wash the vehicle after each use. Keep the equipment
clean.
Note: Do not wash any portion of the equipment while it
is hot. Do not use high pressure spray or steam. Use cold
water and automotive cleaners.
1. Use compressed air to clean engine and radiator
fins. A special blow gun is available through
Cushman Dealer.
2. Use only fresh water for cleaning your equipment.
Note: Use of salt water or affluent water has been known
to encourage rust and corrosion of metal parts resulting
in premature deterioration or failure. Damage of this
nature is not covered by the factory warranty.
3. Do not spray water directly at the dash panel,
ignition switch, controls, or any other electrical
components, or at bearing housings and seals.
4. Clean all plastic or rubber trim with a mild soap
solution or use commercially available vinyl/rubber
cleaners.
Repair damaged metal surfaces and use touch-up paint.
Wax the equipment for maximum paint protection.
!
CAUTION
Clean grass and debris from drives, muffler, and
engine to prevent fires.
All manuals and user guides at all-guides.com
MAINTENANCE
Open the front cowl and locate the OBD-II connector on
the brake fluid reservoir bracket. Plug an OBD-II reader
into the connector, turn ignition switch to the ON position
(do not start engine), and refer to the instructions
included with the reader to retrieve diagnostic codes.
Refer to the Truckster Technical Repair Manual for code
descriptions.
5
en-33