Textron Jacobsen CUSHMAN Turf Truckster Manuel De Maintenance page 21

5.8 AIR FILTER _______________________________________________________________
Do not remove the element for inspection or cleaning.
Unnecessary removal of the filter increases the risk of
injecting dust and other impurities into the engine.
When service is required first clean the outside of the
filter housing, then remove the old element as gently as
possible and discard.
1. Carefully clean the inside of the filter housing without
allowing dust into the air intake.
2. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
3. Assemble the new element and make sure it seats
properly.
4. Reassemble cap making sure it seals completely
around the filter housing. Dust evacuator (A) must
be facing down.
5. Check all hoses and air ducts. Tighten hose clamps.
Replacement (Diesel Only)
1. Clean the outside of the filter housing, especially
around hose connections and cover.
2. Note location of hoses. Loosen hose clamps and
remove both hoses from air cleaner. Use caution to
prevent dust or other debris from entering engine
intake hose.
3. Remove air cleaner mounting hardware (B). Air filter
is secured with a single screw and nut.
4. Lift the air cleaner assembly out of the vehicle.
5.9 JUMP STARTING __________________________________________________________
Before attempting to jump start the vehicle check the
condition of the discharged battery.
Engage parking brake of both vehicles, shift transmission
to Neutral and turn off all electrical loads.
!
WARNING
Batteries generate explosive hydrogen gas. To reduce
the chance of an explosion avoid creating sparks near
battery. Always connect the Negative jumper cable to
the frame of the vehicle with the discharged battery
away from the battery.
All manuals and user guides at all-guides.com
MAINTENANCE
5. Unsnap retaining clamps and remove the old
element as gently as possible and discard.
6. Carefully clean the inside of the filter housing
without allowing dust into the air intake.
7. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
8. Assemble the new element and make sure it seats
properly.
9. Assemble cap making sure it seals completely
around the filter housing. Dust evacuator (A) must
be facing down.
10. Install air cleaner assembly into the vehicle. Secure
with hardware (B).
11. Connect both hoses and tighten hose clamps.
Gas Engine
A
When connecting jumper cables:
1. Stop the engine on the vehicle with a good battery.
2. Connect RED jumper cable to the Positive (+)
terminal on the good battery and to the Positive (+)
terminal on the discharged battery.
3. Connect the BLACK jumper cable from the Negative
(-) terminal on the good battery to the frame of the
vehicle with the discharged battery.
After cables have been connected start the engine on the
vehicle with the good battery then start the vehicle with
the discharged battery.
5
A
Diesel Engine
en-21