IMEON ENERGY IMEON 9.12 Guide De Montage page 135

A – INSTALLATION
Procedure
Make sure that there is a distance of
50 cm around the IMEON
Do not install IMEON in a place where
the temperature or the humidity are
out of the authorized limits.
A1
Ensure proper air circulation to
dissipate heat.
Do not mount the inverter on
inflammable construction materials
Mount on a solid surface.
Check that the battery bank is installed
A2 in a dry and with proper air circulation
location, far from any water sources.
B – CONNECTING GROUND
Procedure
Make sure that the ground cable is
B1
correctly connected to the earth.
Connect the ground to the Earth
B2
terminal (this symbol
Manuel d'installation / Installation guide IMEON 9.12 – Rev A.8
IMEON 9.12
Installation to the wall must be
implemented with the proper
screws so that the solar inverter
can be easily attached to the wall.
The device must be bolted
securely.
Drill six holes in the marked
locations with six screws.
Place the wall plate against the
surface and fix it with M10 screws.
The battery bank must be correctly
installed, stable and secured. If
necessary, adjust the set-up.
Use adapted cross- section cables
according to the current and
distance.
Check the ground terminal block on
the inverter is correctly connected,
together with the common ground
).
of the electrical installation.
Specifications
Specifications
Measures / Test
Observations checked
Measures / Test
Observations checked
Earth
Ground
135
FR
FR
EN