Lead-Acid Batteries - IMEON ENERGY IMEON 9.12 Guide De Montage

4. Push on the start button directly on the battery. After a few seconds, the message « Battery
detected, Configuring IMEON » appears. This message does not appear during soft battery reboot
(toggle Battery State OFF then ON).
5. As soon as the « Battery ready to start » message appears, switch the Battery State to "ON"
position (
FR
FR
EN
6. A soon as the « Battery operating » message appears, the system is operational and adaptation of
battery configuration is possible.

7.4.2 Lead-Acid Batteries

1. In the « Installer » mode, go to the « Manager / Battery » tab
2. Select the battery technology you use (GEL, AGM, OPZ), and press Ok
3. Wait a few seconds to let the inverter configure the battery charger
4. The system is operational and parameter setting is possible
128
IMEON 9.12
)
Guide de montage / Installation guide IMEON 9.12 – Rev A.8