Type Code For Incremental Tapes With And Without Reference Point - Balluff BML-M0 Série Notice D'utilisation

BML-M0 _ -... / BML T _ _ -...
Magnetic Tape – Magnetic Encoder System
7
Type code (continued)
7.2 Type code for incremental tapes with and without reference point (1-/5-/10-mm system)
Magnetic tape
Construction:
02: linear, incremental, 1.55 mm thick, with adhesive layer
03: linear, incremental, 1.35 mm thick, no adhesive layer
07: linear, incremental, 1.43 mm thick, with adhesive layer
Type:
I: Incremental
Pole width:
3: 1 mm
4: 5 mm
6: 10 mm
Accuracy class:
2: 3 µm (only for pole width 1 mm, max. length 90 mm,
no reference point)
3: 5 µm (only for pole width 1 mm, max. length 200 mm,
no reference point)
4: 8 µm (only for pole width 1 mm)
5: 18 µm (only for 1 mm and 5 mm pole width)
6: 50 µm (only for pole width 5 mm)
8: 250 µm (only for pole width 10 mm)
Cover strip:
0: without cover strip
3: with cover strip , H = 0.15 mm
Length L1 (in cm)
1), 2)
Reference point position in cm
R0000:
R0010(L2)/0000:
R0030(L2)/0060(L3+L2):
C0006(L2)/0050(L3):
20 english
BML - M_ _ - I_ _ - A_ - M_ _ _ _ - R/C_ _ _ _(/_ _ _ _)
:
1), 3)
No reference point, or pole-periodic reference point
A reference point at 10 cm.
3)
The position is calculated from the beginning of the tape.
Two reference points
3)
0030 = Location of reference point 1
0060 = Location of reference point 2
The positions are calculated from the beginning of the tape.
Periodic reference point :
3)
A reference point is always 6 cm from the start of the tape.
The following intervals are available for all further reference points:
– Pole width 1 mm: 0002, 0005, 0010, 0020, 0050 (every 2, 5, 10, 20 or 50 cm)
– Pole width 5 mm: 0005, 0010 (every 5 or 10 cm)