Set Up With The Display And Adjustment Module Insert Display And Adjustment Module - Balluff BMD 1L K Série Notice D'utilisation

7 Set up with the display and adjustment module
32
7 Set up with the display and adjustment
module
7.1 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
ent positions - each displaced by 90°. It is not necessary to interrupt
the power supply.
Proceed as follows:
1. Unscrew the housing lid
2. Place the display and adjustment module on the electronics in the
desired position and turn it to the right until it snaps in.
3. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
Fig. 17: Insertion of the display and adjustment module with single chamber
housing
Note:
module for continuous measured value indication, a higher lid with an
inspection glass is required.
-