Startup; Starting Up The System; Operating Notes - Balluff BTL7-P511-M J-DEXC-TA12 Série Notice D'utilisation

BTL7-P511-M _ _ _ _ -J-DEXC-TA12
Magnetostrictive Linear Position Sensor – Rod Style
5

Startup

5.1

Starting up the system

DANGER
Uncontrolled system movement
When starting up, if the position measuring system is part
of a closed loop system whose parameters have not yet
been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
(especially after replacing the BTL or electronics
module). Recalibrate the BTL, if necessary.
5.2

Operating notes

– Check the function of the BTL and all associated
components on a regular basis.
– Take the BTL out of operation whenever there is a
malfunction.
– Secure the system against unauthorized use.
16 english
Ignition protection "d"
Flameproof enclosure