Balluff BTL7-P511-M J-DEXC-TA12 Série Notice D'utilisation page 7

Certificate:
2411253
Project: 70099158
CSA C22.2 No. 142-M1987
CAN/CSA-C22.2 No. 60079-0:07
CAN/CSA-C22.2 No. 60079-1:07
CAN/CSA-C22.2 No. 60529:05
FM 3600-1998
FM 3615-2006
FM 3810-2005
ANSI/ISA-60079-0 (12.00.01)-2009
ANSI/ISA-60079-1 (12.22.01)-2009
ANSI/UL 50, 12 Ed.
th
ANSI/UL 50E, 1 Ed.
st
ANSI/IEC 60529-2004
MARKINGS
MARKINGS
The manufacturer is required to apply the following markings:
Products shall be marked with the markings specified by the particular product standard.
Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
Nameplate adhesive label material approval information:
The following markings are provided on a 0.018" (0.45mm) thick Stainless Steel nameplate. Nameplate is affixed
to the cover of the enclosure by two M3 by 5mm screws and recessed on the cover to prevent edges from being
bent.
Manufacturer's name: "Balluff Inc.", or CSA Master Contract Number "252588", adjacent to the CSA Mark in
lieu of manufacturer's name.
DQD 507 Rev. 2016-02-18
Process Control Equipment - Industrial Products
Electrical apparatus for explosive gas atmospheres – Part 0: General
requirements
Electrical apparatus for explosive gas atmospheres – Part 1: Flameproof
enclosures "d"
Degrees of protection provided by enclosures (IP Code)
Electric Equipment for use in Hazardous (Classified) Locations General
Requirements
Explosionproof Electrical Equipment - General Requirements
Electrical Equipment for Measurement, Control and Laboratory Use
Explosive atmospheres – Part 0: Equipment – General Requirements
Explosive Atmospheres - Part 1: Equipment Protection by Flameproof
Enclosures "d"
Enclosures for Electrical Equipment, Non-Environmental Considerations
Enclosures for Electrical Equipment, Environmental Considerations
Degrees of protection provided by enclosures (IP Code)
Page 3
Master Contract: 252588
Date Issued: 2016-11-23