Operation Via App / Web Tool; Reset; Brine Earth Heat Exchanger Control; Zone Ventilation - Maico WR 310 Notice De Mise En Service Et D'entretien

As an installer: Enter user name service
and password 6940. The web server
opens.
You can now access your ventilation
i
unit from any PC in your network via
http://maicokwl.
5. Undertake commissioning.
6. Remove connecting cable. Fit front cover
and front plate.

8.9 Operation via app / web tool

310/410 320/470
160 Flat 300 Flat
1. Connect as described in Chapter 8.8,
steps 1 to 4. In step 2, under Settings/
Internet in the web server also set air@
home parameter to yes.
web tool (www.air-home.de)
2. Call up
app.
or
3. Log in with the access details emailed to
you during registration.

8.10 RESET

310/410 320/470
160 Flat 300 Flat
Unit settings are permanently lost
i
during a reset. Back up the data with
the commissioning software before
resetting.
The unit settings can be reset with the two
reset functions  Chapter 6.2.
Resetting customer & installer level
Complete reset, all unit parameters are reset
to the factory settings.
Resetting customer level
The owners and tenant settings are deleted.
The settings undertaken in the installer menu
are retained.
170
Trio
170
Trio
9 Functions of additional circuit board 1 | UK
9 Functions of additional circuit
board 1
310/410 320/470
160 Flat 300 Flat
There are 3 slots (170 units: 2 slots) for
optional additional circuit boards (ZP1 or ZP2)
on the control console. Any combination of
circuit boards is possible. Installation is as
described in the accessories instructions.
DIP switch setting options (only 1 function
can be set)
Brine earth heat exchanger, zone ventilation,
3-way air shutter or supplementary heating.

9.1 Brine earth heat exchanger control

The outside air can be heated in the winter
and cooled in the summer with a brine earth
heat exchanger.
No extra temperature sensor is needed to
control the brine circulating pump (controlled
or uncontrolled brine CP). This is handled by
the air inlet temperature sensor in the ventila-
tion unit.
If heating, the brine CP is controlled using
the unit-specific frost protection strategy
 Chapter 8.4. For more information
 Chapter 6.8.

9.2 Zone ventilation

Zone ventilation setting  Chapter 6.9.
Units with zone ventilation can feed different
amounts of the volumetric air flow provided
into 2 room zones. For example, into zone 1
(living areas) and zone 2 (bedrooms).
● The volumetric flow of one zone can be
reduced by up to 60 %.
● Zone ventilation is only active in the nominal
ventilation level. It is deactivated in the other
ventilation levels or if the bypass is open.
Zones 1 and 2 are set in Auto Time operating
mode using a time programme. 4 time seg-
ments can be saved per day with supply air
volumes defined for zones 1 and 2  Chap-
ter 6.4.
170
89