Foreword; Unpacking; Connection; Important - Dru SAXO SL 70 Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its
natural draught draws in the combustion air from outside
through a combined inlet-outlet system. The same natural
draught expels the combustion gasses.
The safe operation of the appliance is guaranteed by the
use of a second thermocouple fitted to the main burner.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
gasinstaller.

Important

• The chimney breast should be adequately vented.
• The appliance must not be packed or covered in any way
whatsoever.
• Always clean the glass pane before using the gas fire, to
prevent any finger marks or other dirt getting burnt into
the glass.
• This appliance may only be installed using the Ø150/Ø80
flue material supplied by DRU.
• NB: To ensure the ignition works properly, the ignition
wire must come into as little contact as possible with
the metal parts of the heater and should therefore
not be wound round the gas or pilot-light pipes or the
thermocouple.
• Make sure thermocouple 2 and the space around it are
kept free.
• Place the electrical wiring in such a way that they are free
from the appliance.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance can only be used and is only suitable for
the country and the type of gas mentioned on the type
identification tag. Please check that the local gas and
pressure correspond with the specifications on the type
identification tag. The type identification tag is a metal
plate. The metal plate is on a chain and that is where it
should stay. All regulations regarding gas installation,
including any local regulations, must be observed at all
times. The appliance is to be installed by a registered
gasinstaller.
Gas pressure/pre-pressure
The burner pressure is factory adjusted; see type plate. It
is not necessary to test the burner pressure.
The pre-pressure in domestic installations should be
tested however, as this can vary.
- Test the pre-pressure; see Fig. 10 for the pressure
testing nipples on the gas control block.
- Contact the power company if the pre-pressure is not
right.
Important
• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered gasinstaller.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to
dry.
• For safety reasons a guard should be placed in front of the
fire at all times.

Positioning the appliance

The appliance has been designed to be built snugly into
a newly built chimney breast, made of incombustible and
heat-resistant material.
If you build a chimney breast made of any material other
than stone (e.g. Promatect), we advise you to use glass
fibre wallpaper rather than plaster. Cracks can form at
the corners of the chimney breast as they are immediately
above one of the hottest parts of the heater.
Allow sufficient space for the depth of the appliance.
20
fig. 10