Foreword; Unpacking; Connection; Important - Dru Paco Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its natu-
ral draught draws in the combustion air from outside
through a combined inlet-outlet system.The same natural
draught expels the combustion gasses.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these instruc-
tions and the manual carefully to familiarize yourself with
the appliance. If you require any further support, please do
not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered gasin-
staller.

Important

• The chimney breast should be adequately vented.
• The appliance must not be packed or covered in any way
whatsoever.
• Always clean the glass pane before using the gas fire, to
prevent any finger marks or other dirt getting burnt into
the glass.
• This appliance may only be installed using the Ø150/Ø100
flue material supplied by DRU.
• NB: To ensure the ignition works properly, the ignition
wire must come into as little contact as possible with the
metal parts of the heater and should therefore not be
wound round the gas or pilot-light pipes or the thermo-
couple.
• The pilot burner and the space around it must always be
kept clear of obstruction so that the flame remains
unblocked at all times.
• It is vitally important that you adhere to the correct posi-
tioning of the logs as specified. Failure to do this may
result in an unsafe situation.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance can only be used and is only suitable for the
country and the type of gas mentioned on the type identi-
fication tag. Please check that the local gas and pressure
correspond with the specifications on the type identifica-
tion tag.The type identification tag is a metal plate, which
is on the chain. All regulations regarding gas installation,
including any local regulations, must be observed at all
times.The appliance is to be installed by a registered
gasinstaller.
Important
• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered gasinstaller.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to dry.
Positioning the appliance (fig. 1 and 2)
The appliance has been designed to be built snugly into a
newly built chimney breast, made of incombustible and
heat-resistant material.
If you build a chimney breast made of any material other
than stone (e.g. Promatect), we advise you to use glass
fibre wallpaper rather than plaster. Cracks can form at the
corners and the edges of the chimney breast as they are
immediately above one of the hottest parts of the heater.
Allow sufficient space for the depth of the appliance.
The built-in height will depend on how the adjustable feet
are set.The feet can be adjusted to the required length,
and can be fixed with self-drilling screws (2) in the interior,
see fig. 1.The extension supports can be additional
ordered. Build the chimney breast accurately.The sawn
edge of the chimney breast must be straight and neatly
finished.
Remove the glass window of the combustion chamber and
remove the box of logs and bag of accessories.
Y
X
38c-1152
20
7
9
8
3
5
4
6
2
1
fig. 1