Foreword; Unpacking; Connection; Instructions For Installation - Dru PALAZZO 03 Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its
natural draught draws in the combustion air from outside
through a combined inlet-outlet system.The same natural
draught expels the combustion gasses.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
installer.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance is suitable for G20 or G25 natural gas.
Please check that the local gas and pressure correspond
with the specifications on the type identification tag.The
type identification tag is a metal plate hanging on a chain.
All regulations regarding gas installation, including any local
regulations, must be observed at all times. The appliance is
to be installed by a registered installer.

Important

• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered installer.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to
dry.
Positioning the fire
The fire has been designed to be built either into a new
fireplace or tightly into a wall without a fireplace.
Allow sufficient space for the depth of the appliance
(400 mm).
N.B.: work accurately, allowing for the narrow flange on
the inside.
Positioning the appliance in a new fireplace
Position the appliance at the required height and connect
it. Finish the fireplace.
Fitting the appliance tightly in a wall without a
fireplace (fig. 4)
Stand the fire on a plateau.
The plateau should be at least 10 mm lower than the
bottom of the hole so that the front overlaps the hole by
5 mm at the bottom. Connect the appliance.
Make a rectangular hole of incombustible and heat-
resistant material (e.g. promatec)
898 mm high and 677 mm wide
38c-1062
12
fig.4