Fitting The Glass Panel; Mounting The Front Panel; Remote Control; Connecting The Receiver - Dru PALAZZO 03 Instructions D'installation Et Mode D'emploi

Fitting the glass panel

Once the logs are in place, the glass can be replaced in the
brackets nges and tightened with the two socket-head
bolts. In the event of damage or breakage, the glass should
be replaced immediately.
Mounting the front panel (fig. 9)
The coloured or stainless steel frame (A) is packed
separately from the basic set.The frame is fitted to the
front panel (B) using the 8 bolts supplied (C). Make sure
that the tall edge is at the bottom.
A B

Remote control

Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.

Connecting the Receiver

The remote control system comprises a receiver and a
remote control, packed together in one box. The receiver
must be connected to the appliance fitting the batteries.
This is done as
follows:
• Take the receiver out
of the box.
• Slide the white plug
of the cable onto the
receiver circuit
board (fig. 8).
• Connect the wires
to the connectors
on the gas control
valve.The different
sized plugs
correspond with the connectors on the gas control valve.
• Open the lid.
• Insert 4 penlight batteries (type AA). Make sure they are
C
Tall edge
Hoge rand
fig. 9
fig. 8
OPERATING INSTRUCTIONS
the right way round.
• Replace the lid.
• Place the reciever under the aplicance on the floor. Place
the reciever as far away from the burner tray as possible
to prevent the reciever from getting too hot. Making sure
that the red LED points forwards.

Replacing the batteries in the receiver

• Open the door at the front.
• Take the receiver and open the lid.
• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit,
press both buttons for a few seconds and it will change to
Celsius.
NB: Do not throw old batteries in the dustbin.They
should be treated as Chemical Waste.
17
Palazzo