Fitting The Appliance - Dru ROMANO Instructions D'installation Et Mode D'emploi

Fitting the appliance

The design of this fire is such that the casing can be
completely built in first, in a fireplace or chimney breast (of
incombustible and heat-resistant material) and the
appliance itself slid into place afterwards. Any existing
chimney should first be professionally cleaned before
connecting the appliance to it.The flue duct should be
fitted with an effective chimney cowl, to ensure a good
draught in the chimney no matter what the wind
conditions are.The type of chimney cowl and the position
of the opening must meet any applicable local standards, to
ensure it works properly.To build the casing into the
fireplace, a rectangular hole must be made that is:
min. 530 high and min. 875 wide
Allow for the depth of the heater itself (350 mm).
Construct the chimney accurately allowing for the size of
the flange on the casing.
• Take out the glass pane (fig.1) by removing the glass strip
at the top (1).This is fitted with 5 self-tapping screws (2).
• Slide the interior out of the casing. by unscrewing the 4
socket-head screws (3).
• Dismantle the outlet connector (4) by removing the 2 self-
tapping screws (5), (fig.2).
• First slide the flue pipes into the chimney and fix them to
leave sufficient room underneath to slide the casing into
the fireplace or chimney breast.
3
3
2
1
fig. 1
INSTRUCTIONS FOR INSTALLATION
• Place the casing in the opening and feed the gas pipe
through the slot on the right.
• Feed the flue ducts through into the outlet connector.
• Reconnect the outlet connector (4) with the 2 self-tapping
screws (5). After tightening the self-tapping screws, loosen
them 1/8 turn to make it easier to slide the sides of the
outlet connector between the slots (6) in the baffle, (fig.3).
• Slide the interior back into the casing.The outlet will
automatically be centred in the slots (6) of the baffle. Fix
the interior in place with the 4 socket-head screws (3).
• Connect the gas pipe to the gas control block and check
the connections for leaks.
The appliance has been adjusted for G20 natural
gas with a pre-pressure of 20 mbar. For use with
G25 natural gas, see instructions elsewhere in this
booklet: Adjusting for G25 natural gas.
6
15
5
4
fig. 2
6
fig. 3
Romano/Armano