Positioning The Logs Or White Carrara Stones - Dru ROMANO Instructions D'installation Et Mode D'emploi

Positioning the logs or white carrara stones

The appliance is supplied either with a set of logs or with
white carrara stones.
Positioning the logs
• Fill the burner tray with vermiculite (10) and distribute
evenly, (fig. 8).
• Fill the vermiculite tray with chips (11) and distribute this
evenly too, (fig. 8).
• Make sure the slot between the burner tray and the
vermiculite tray stays open.
• Make sure that no vermiculite and/or chips get on or
between the (oxypilot) pilot light burner (12) as this could
prevent the pilot light from working properly (fig. 8).
• Position the logs (fig.9) as illustrated (fig.10).
INSTRUCTIONS FOR INSTALLATION
Positioning the white carrara stones
• Fill the burner tray with vermiculite (10) and distribute
evenly, (fig. 8).
• Fill the burner tray and the surrounding tray with the
white carrara stones, (figs. 11 and 12). Distribute the
stones in a single layer. Stones on top of each other will
distort the flame effect.
• Make sure that there are no stones in front of the opening
of the (oxypilot) pilot light burner (12) as this could
prevent the pilot light from working properly
(figs. 11 and 12).
• N.B.:The burner tray must always be filled with
vermiculite.This is essential to warrant the long
service life of the burner tray.
You can "play" with the flames by moving the vermiculite
and chips about on the burner bed until you have created
the desired flame effect.
Do not use any materials other than those supplied.
The supplied materials are incombustible and have been
manufactured specifically for this appliance.
Once the logs or stones are in position, the
glass pane can be replaced and fixed with the glass strip
(1) and the 5 self-tapping screws (2) (fig.1).
10
12
fig. 8
17
11
Romano/Armano