Connecting To The Gas Supply; Positioning The Logs - Dru Maestro Instructions D'installation Et Mode D'emploi

1
3
38C-1107
fig. 2
4
5
38C-1108
fig. 3
2
3
INSTRUCTIONS FOR INSTALLATION

Connecting to the gas supply

Use an approved connecting tap with coupling in the
supply pipe (for Belgium this must be B.G.V. approved).
In addition:
• Expel the air from the supply pipes before connecting
the appliance.
• Avoid pressure on the gas control block and the pipes.
• Check all connections for gas tightness.

Positioning the logs

Maestro fig. 4
Position the logs as follows:
• Lay the large log against the back wall.
Pay attention !!!!! It's important that the log lay completly
against the back wall
• Fill the burner with vermiculite (this is in the plastic bag
with the log set).
• Spread it evenly over the burner tray and the
surrounding tray.
• G20/G25 (Natural gas): Sprinkle the bag of brown embers,
black and yellow chips on the top of the vermiculiet on
the burner to create a glowing effect on the burner bed.
• If this appliance is to be used with G31 (propane) do not
sprinkle any embers or chips on top of the vermiculite
on the burner as this can cause soot to accumulate.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.
• Now lay the rest of the logs in place as illustrated in
fig. 4.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.
The supplied materials are incombustible and have been
19
Maestro